|
|
Mubychem Group, established in 1976, is the pioneer manufacturer of Zinc Chloride, Ammonium Chloride, Calcium Chloride, Potassium Chloride, Sodium Acetate, Sodium Thiosulphate, Ammonium Alum, Pharmaceutical, Fragrance & Flavor chemicals in India. Mubychem Group has several manufacturing facilities spread across Western India. |
For Translating this page in your language use this translation tool (Refresh if the tool is not seen). |
--------
--------
Ammonium Alum Manufacturers Aluminum Ammonium Sulfate MSDS
Buy
Ammonium Alum; Door Delivery
Aluminum Ammonium Sulfate Ammonium Alum USP BP IP ACS FCC AR
Ammonium Alum
Technical & Pure Crystals, Aluminum Ammonium Sulfate.
Also IP BP Ph. Eur. USP ACS AR LR FCC Food Grades
Synonyms: Aluminum ammonium
disulfate dodecahydrate; Aluminum ammonium disulfate, 12-hydrate; Ammonium alum;
sulfuric acid aluminum ammonium salt (2:1:1), dodecahydrate
CAS No.: 7784-25-0 (Anhydrous) 7784-26-1 (Dodecahydrate)
Molecular Weight: 453.32
Chemical Formula: AlNH4(SO4)2 . 12H2O
Ingredient: Sulfuric Acid, Aluminum Ammonium Salt (2:1:1) or Aluminum Ammonium Sulfate or Ammonium Alum
CAS No.: 7784-25-0
Percent: 98 - 100%
Hazardous: Yes
Potential Acute Health Effects:
Hazardous
in case of eye contact (irritant), of ingestion, of inhalation. Slightly
hazardous in case of skin contact (irritant).
Potential Chronic Health Effects:
CARCINOGENIC EFFECTS: Not available.
MUTAGENIC
EFFECTS: Not available.
TERATOGENIC
EFFECTS: Not available.
DEVELOPMENTAL TOXICITY: Not available.
Repeated or prolonged exposure is not known to aggravate medical condition.
Aluminum Ammonium Sulfate or Ammonium Alum hydrolyzes in water to form sulfuric
acid, which is responsible for the irritating effects given below.
Inhalation: If inhaled, remove to fresh air. If not breathing, give artificial
respiration. If breathing is difficult, give oxygen. Get medical
attention.
Ingestion:
If swallowed, DO NOT INDUCE VOMITING. Give large quantities of water. Never give
anything by mouth to an unconscious person. Get medical attention immediately.
Skin Contact:
Wipe off excess material from skin then immediately flush skin with plenty
of water for at least 15 minutes. Remove contaminated clothing and shoes. Get
medical attention. Wash clothing before reuse. Thoroughly clean shoes before
reuse.
Eye Contact:
Check for and remove any contact lenses. In case of contact, immediately
flush eyes with plenty of water for at least 15 minutes. Cold water may be used.
WARM water MUST be used. Get medical attention.
Flammability of the Product: Aluminum Ammonium Sulfate or Ammonium Alum
Non-flammable.
Auto-Ignition Temperature: Not applicable.
Flash
Points: Not applicable.
Flammable Limits: Not applicable.
Products
of Combustion: Not available.
6. Accidental Release Measures
Cover spill with soda ash and mix. Ventilate area of leak or spill. Keep unnecessary and unprotected people away from area of spill. Wear appropriate personal protective equipment. Pick up and place spills in a suitable container for reclamation or disposal, using a method that does not generate dust.
7. Handling and Storage
Keep Aluminum Ammonium Sulfate or Ammonium Alum in a tightly closed container, stored in a cool, dry, ventilated area. Protect against physical damage. Isolate from incompatible substances. Containers of Aluminum Ammonium Sulfate or Ammonium Alum material may be hazardous when empty since they retain product residues (dust, solids); observe all warnings and precautions listed for the product.
8. Exposure Controls/Personal Protection
Airborne Exposure Limits:
-OSHA Permissible Exposure Limit (PEL):
15 mg/m3 (TWA) total dust and 5 mg/m3 (TWA)
respirable fraction for Aluminum metal as Al.
-ACGIH Threshold Limit Value (TLV):
1 mg/m3 respirable fraction (TWA), Aluminum metal and Insoluble compounds, A4.
Ventilation System:
A system of local and/or general exhaust is recommended to keep employee
exposures below the Airborne Exposure Limits. Local exhaust ventilation is
generally preferred because it can control the emissions of the contaminant at
its source, preventing dispersion of it into the general work area. Please refer
to the ACGIH document, Industrial Ventilation, A Manual of Recommended
Practices, most recent edition, for details.
Personal Respirators (NIOSH Approved):
If the exposure limit of Aluminum Ammonium Sulfate or Ammonium Alum is
exceeded, a half-face dust/mist respirator may be worn for up to ten times the
exposure limit or the maximum use concentration specified by the appropriate
regulatory agency or respirator supplier, whichever is lowest. A full-face piece
dust/mist respirator may be worn up to 50 times the exposure limit, or the
maximum use concentration specified by the appropriate regulatory agency, or
respirator supplier, whichever is lowest. For emergencies or instances where the
exposure levels are not known, use a full-face piece positive-pressure,
air-supplied respirator. WARNING: Air-purifying respirators do not protect
workers in oxygen-deficient atmospheres.
Skin Protection:
Wear impervious protective clothing, including boots, gloves, lab coat,
apron or coveralls, as appropriate, to prevent skin contact.
Eye Protection:
Use chemical safety goggles and/or full face shield where dusting or
splashing of solutions is possible. Maintain eye wash fountain and quick-drench
facilities in work area.
9. Physical and Chemical Properties
Appearance: Aluminum
Ammonium Sulfate or Ammonium Alum is colorless crystals.
Odor: Odorless.
Solubility: 14% in water, 200% in boiling water
Density:
1.65
pH: 4.6 (0.05M solution)
% Volatiles by volume @ 21C (70F): 0
Boiling Point: 280C (536F) Decomposes.
Melting Point:
94.5C (201F)
Vapor Density (Air=1): No information found.
Vapor Pressure (mm Hg): No information found.
Evaporation Rate (BuAc=1): No information found.
10. Stability and Reactivity
Stability: Aluminum
Ammonium Sulfate or Ammonium Alum is stable under ordinary conditions of use and
storage.
Hazardous Decomposition Products: Toxic oxides of nitrogen, sulfur
dioxide, ammonia, and sulfur trioxide may form at elevated temperatures.
Hydrolyzes to form sulfuric acid.
Hazardous Polymerization: Will not occur.
Incompatibilities: Contact with alkalis may release ammonia gas.
Corrosive to metals in the presence of water.
Conditions to Avoid: Moisture and incompatibles.
11. Toxicological Information
No LD50/LC50 information found relating to normal routes of occupational
exposure.
--------\Cancer Lists\------------------------------------------------------
---NTP Carcinogen---
Ingredient Known Anticipated IARC Category
------------------------------------ ----- ----------- -------------
Sulfuric Acid, Aluminum Ammonium No No None
Salt (2:1:1) (7784-25-0)
Aluminum Ammonium Sulfate or Ammonium Alum
12. Ecological Information
Environmental Fate: No
information found.
Environmental Toxicity: No information found.
13. Disposal Considerations
Whatever cannot be saved for recovery or recycling should be managed in an appropriate and approved waste disposal facility. Processing, use or contamination of this product may change the waste management options. State and local disposal regulations may differ from federal disposal regulations. Dispose of Aluminum Ammonium Sulfate or Ammonium Alum container and unused contents in accordance with federal, state and local requirements.
14. Transport Information
Not regulated.
15. Regulatory Information
--------\Chemical Inventory Status - Part 1\---------------------------------
Ingredient TSCA EC Japan Australia
----------------------------------------------- ---- --- ----- ---------
Sulfuric Acid, Aluminum Ammonium Salt (2:1:1) Yes Yes Yes Yes
(7784-25-0)
--------\Chemical Inventory Status - Part 2\---------------------------------
--Canada--
Ingredient Korea DSL NDSL Phil.
----------------------------------------------- ----- --- ---- -----
Sulfuric Acid, Aluminum Ammonium Salt (2:1:1) Yes Yes No No
(7784-25-0)
--------\Federal, State & International Regulations - Part 1\----------------
-SARA 302- ------SARA 313------
Ingredient RQ TPQ List Chemical Catg.
----------------------------------------- --- ----- ---- --------------
Sulfuric Acid, Aluminum Ammonium Salt No No No No
(2:1:1) (7784-25-0)
--------\Federal, State & International Regulations - Part 2\----------------
-RCRA- -TSCA-
Ingredient CERCLA 261.33 8(d)
----------------------------------------- ------ ------ ------
Sulfuric Acid, Aluminum Ammonium Salt No No No
(2:1:1) (7784-25-0)
Chemical Weapons Convention: No TSCA 12(b): No CDTA: No
SARA 311/312: Acute: Yes Chronic: No Fire: No Pressure: No
Reactivity: No (Pure / Solid)
Australian Hazchem Code: None allocated.
Poison Schedule: None allocated.
WHMIS (Canada): Not controlled under WHMIS (Canada).
DSCL (EEC):
R36/37- Irritating to eyes and respiratory system. S24/25- Avoid contact
with skin and eyes. S26- In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice. S36/37/39- Wear suitable
protective clothing, gloves and eye/face protection.
HMIS (U.S.A.):
Health Hazard: 2
Fire Hazard: 0
Reactivity: 0
Personal Protection: E
National Fire Protection Association (U.S.A.):
Health: 2
Flammability: 0
Reactivity: 0
Specific hazard:
Protective Equipment:
Gloves. Lab coat. Dust respirator. Be sure to use an approved/certified
respirator or equivalent. Splash goggles.
16. Other Information
NFPA Ratings: Health: 1
Flammability: 0 Reactivity: 0
Label Hazard Warning:
WARNING! HARMFUL IF SWALLOWED OR INHALED. CAUSES IRRITATION TO SKIN, EYES
AND RESPIRATORY TRACT.
Label Precautions:
Avoid breathing dust.
Keep container closed.
Use only with adequate ventilation.
Wash thoroughly after handling.
Avoid contact with eyes, skin and clothing.
Label First Aid:
If swallowed, DO NOT INDUCE VOMITING. Give large quantities of water. Never
give anything by mouth to an unconscious person. If inhaled, remove to fresh
air. If not breathing, give artificial respiration. If breathing is difficult,
give oxygen. In case of contact, wipe off excess material from skin then
immediately flush eyes or skin with plenty of water for at least 15 minutes.
Remove contaminated clothing and shoes. Wash clothing before reuse. In all
cases, get medical attention.
Disclaimer:
************************************************************************************************************
Our company provides this Aluminum Ammonium Sulfate or Ammonium Alum MSDS
information contained herein in good faith but makes no representation as to its
comprehensiveness or accuracy. This Aluminum Ammonium Sulfate MSDS Sheet or Ammonium Alum
MSDS sheet is intended only as a guide to the appropriate precautionary
handling of the material by a properly trained person using this product.
Individuals receiving the information must exercise their independent judgment
in determining its appropriateness for a particular purpose.
************************************************************************************************************
Aluminium Ammonium
Sulphate Manufacturers
Ammonium Alum manufacturers:
MUBY CHEMICALS
S-8, SARIFA MANSION, 2ND FLANK ROAD,
CHINCHBUNDER, MUMBAI 400009, INDIA
TEL: (OFFICE) 91-22-23770100, 23726950,
23774610, 23723564. FAX: 91-22-23728264
e-mail:
info@mubychem.com
Cell Call
to Anmol: +91-9821870100
USA & Canadian Customers may Call
773-829-5811
Copyright and Usual Disclaimer is
Applicable.
Last updated
06 December, 2011
----------------
| Old Spice: Manufacturing since more than Three Decades: | |||
|
Best Selling IP BP USP FCC ACS Grades of Chemicals by Anmol Chemicals |
|||
| Borax; Sodium Borate | |||
| Calcium Chloride | |||
| Chromic Chloride | |||
| Manganese Chloride | Manganese Sulfate | Methylene Blue | Potassium Chloride |
| Sodium Acetate | Sodium Hydroxide | Sodium Thiosulfate | |
| Zinc Chloride | |||
|
Pharmaceuticals & Food Grade, IP BP USP FCC ACS Gr. of Chemicals mfd. by Anmol Chemicals |
|||
| Sodium Citrate | Titanium Dioxide | ||
| Zinc Carbonate | |||
| Aluminum Ammonium Sulfate Manufacturers |
|
||
Global or International Ammonium Alum - Aluminum Ammonium Sulfate - Aluminium Ammonium Sulphate Suppliers, Exporters, Importers, Manufacturers
Exports to USA UAE Europe Africa Tanzania Kenya Uganda Egypt Turkey Brazil Chile Argentina Dubai etc.
----------------